we reserve the right to make changes to improve technical design and may do so without further notice. parameters can vary in different applications.all operating parameters must be validated for each customer application by the c ustomer. led - lamp 16.11.2007 rev. 05 radiation red maximum ratings t amb = 25c, unless otherwise specified symbol value unit i f 30 ma i fm 100 ma t amb -20 to +85 c t stg -55 to +100 c junction temperature t j 100 c soldering temperature t sd 260 c optical and electrical characteristics t amb = 25c, unless otherwise specified parameter test conditions symbol min typ max unit forward voltage i f = 20 ma v f 2.0 2.3 v reverse voltage i r = 10 a v r 5v radiant power i f = 20 ma e 34 mw luminous intensity i f = 20 ma i v 700 1000 mcd radiant intensity i f = 20 ma i e 15 20 mw/sr peak wavelength i f = 20 ma p 650 655 660 nm dominant wavelength i f = 20 ma d 640 nm spectral bandwidth at 50% i f = 20 ma ? 0.5 22 nm viewing angle i f = 20 ma ? 20 deg. switching time i f = 20 ma t r, t f 70 ns note: all measurements carried out on epigap equipment storage temperature range type ddh (t p 50 s, t p /t = 1/2) optical communications, safety equipment, automation forward current (dc) peak forward current description parameter test onditions ELD-655-533-1 case 5 mm plastic lens technology algaas/algaas *measured after 30s current flow applications high-power, high-speed deep red led in standard 5 mm package, housing without standoff leads t 5 s, 3 mm from case operating temperature range 5,3 - 0,3 9 - 0,5 32,5 2 - 1,0 1,1 - 0,1 0,6 - 0,2 0,8 - 0,4 6 - 0,3 anode 2,54 epigap optoelektronik gmbh, d-12555 berlin, k?penicker str.325 b, haus 201 tel.: +49-30-6576 2543, fax : +49-30-6576 2545 1 of 2
we reserve the right to make changes to improve technical design and may do so without further notice. parameters can vary in different applications.all operating parameters must be validated for each customer application by the c ustomer. led - lamp 16.11.2007 rev. 05 ELD-655-533-1 remarks concerning optical radiation safety* *note: safety classification of an optical component mainly depends on the intended application and the way the component is being used. furthermore, all statements made to classification are based on calculations and are only valid for this led "as it is", and at continuous operation. using pulsed current or altering the light beam with additional optics may lead to different safety classifications. therefore these remarks should be taken as recommendation and guideline only. up to maximum forward current, at continuous operation, this led may be classified as led product class 1 , according to standard iec 60825-1:a2. class 1 products are safe to eyes and skin under reasonably predictable conditions. this implicates a direct observation of the light beam by means of optical instruments. epigap optoelektronik gmbh, d-12555 berlin, k?penicker str.325 b, haus 201 tel.: +49-30-6576 2543, fax : +49-30-6576 2545 2 of 2
|
